E27 Motion Sensor Bulb Holder Z04-Q Adjustable (220V) — Human Body Induction
The adjustable version of our E27 motion sensor holder — same wall or ceiling mounted bulb holder, but with a control knob so you decide how long the light stays on after motion stops.
The Z04-Q adds a TIME adjustment on the front of the housing. That matters more than it sounds: a fixed 30-second delay is fine for a corridor but useless on a staircase you are still climbing. With the knob you can dial the hold time up for stairs and store rooms, or down for a gate light you only need for a moment. If you would rather have nothing to set at all, the Z04-N Fixed is the same holder with factory settings.
Key features
- Built-in PIR sensor — the bulb lights the moment it detects a person
- Light-control (day/night) sensing so it stays off in daylight
- Standard E27 socket — takes LED, energy-saver or filament bulbs
- Surface-mounts to a wall or ceiling; wires straight into your 220V lighting circuit
- Touch-free — nothing to switch, nothing to forget
- Screws and wall plugs included
Where people use it
Staircases, corridors, entrance gates, basements, store rooms, garages and back yards — anywhere a light gets left burning because nobody wants to walk back to the switch.
Which version should I buy?
Z04-Q (this one) — adjustable hold time, best where the right delay depends on the room. Z04-N — fixed timing, nothing to configure.
Wiring & installation guide
We wrote a full guide with a connection diagram for this: E27 motion sensor bulb holder: wiring, setup and Z04-N vs Z04-Q — the two-wire connection diagram and which version suits your room.
Why buy from Arduino Corner
Genuine, tested smart-home gear at the best prices in Pakistan. Visit us: Smart Home | Arduino Corner, Shaheen Market, DAV College Road, Rawalpindi. Same-day delivery in Rawalpindi & Islamabad, cash on delivery nationwide.
